Publication Date
| In 2026 | 0 |
| Since 2025 | 0 |
| Since 2022 (last 5 years) | 0 |
| Since 2017 (last 10 years) | 1 |
| Since 2007 (last 20 years) | 1 |
Descriptor
| Computer Assisted Design | 2 |
| Technology Uses in Education | 2 |
| Visualization | 2 |
| Chemistry | 1 |
| Computer Peripherals | 1 |
| Computer Simulation | 1 |
| Cost Effectiveness | 1 |
| Engineering Education | 1 |
| Hands on Science | 1 |
| Manipulative Materials | 1 |
| Measurement Equipment | 1 |
| More ▼ | |
Publication Type
| Dissertations/Theses -… | 1 |
| Journal Articles | 1 |
| Reports - Descriptive | 1 |
Education Level
Audience
Location
| California | 1 |
Laws, Policies, & Programs
Assessments and Surveys
What Works Clearinghouse Rating
Peer reviewed
Direct linkDavis, Eric J.; Jones, Michael; Thiel, D. Alex; Pauls, Steve – Journal of Chemical Education, 2018
Additive manufacturing (3D printing) is a technology with near-unlimited potential for the chemical educator. However, its adoption into higher education has been limited by the dual requirements of expertise in 3D printing and 3D computer-aided design (CAD). Thus, its reported utilization in the chemistry curriculum has been within the creation…
Descriptors: Chemistry, Science Education, Open Source Technology, Computer Peripherals
Jeffrey Dale Mather – ProQuest LLC, 2003
This dissertation presents information gathered and analyzed through an electronic internet-based Delphi Survey process. The purpose of this study is to identify a consensus of factors that might forecast the future effects of Rapid Prototyping (RP) technology on engineering design education when used for the purpose of overcoming the limitations…
Descriptors: Engineering Education, Computer Assisted Design, Computer Simulation, Visualization
