A cost-effective method has been developed with utmost efficiency for the determination of density of a liquid. The experimental setup for this purpose is a Polyvinyl chloride (PVC) cylinder fitted with an overflow spout, a volume measuring cylinder, a wooden block along with a hook and a known mass taken from scientific weight box. For this…

The laser pointer has been widely used to demonstrate some simple optics phenomena, like reflection, refraction, total reflection, and diffraction. However, the rays of laser light cannot be seen in the air because the scattered light is too weak. Many physics teachers use milk or smoke to visualize rays of laser light in physics labs, but it is…

Water rockets can be used in a variety of ways, from schools to planetariums, with very young kids or adults. We propose here simple forms to work with water rockets, going one step further than a simple launch. A smartphone can be used to film the launch and analyze its motion with video analysis or it can even be attached to the rocket, using…

A standard physics experiment for students is to measure the terminal velocity of an object in air or in glycerine. A more difficult challenge is to measure the terminal velocity in water since the depth of the water needs to be large or the object needs to be dropped in the water at a speed close to its terminal velocity. Results obtained by…

Newton's laws are a ubiquitous topic in introductory physics instruction. One common problem involves asking what will happen if you stick your finger into a cup of water sitting on a scale. A way to solve the problem would be to first recognize that the water exerts a buoyant force upward on the finger, which students can recognize as being the…

Apparatus catalogues of the first half of the 20th century contain a number of clever and simple devices for measuring the index of refraction of a liquid. In some cases students can put together one of these pieces of apparatus and then make their own measurements. The Gilley board was one of the devices that caught my eye, and I would like to…

An experiment using the volumetric flux of a water stream was used to find the initial velocity of the water as it performs parabolic motion. The trajectories were measured with different initial velocities, comparing the maximum height and range values with the theoretical calculations. The closeness of the measured values to the calculations…

In this paper we present a study on the capillary action of water in a glass tube. It is a well-known phenomenon that the rise of a water column in the capillary is governed by parameters such as surface tension of water, radius of the tube, density of water and acceleration due to gravity. The interdependence of the parameters gives rise to the…

This work presents the design of an inexpensive electronic system to measure water temperature and generate an experimental data set used to verify the fitting between experimental and theoretical curves of a water-cooling process. The cooling constant is computed with three different theoretical methods to check their efficiency and this approach…

The physical problem of a body of water in a tank that drains through a hole in the base is a classical problem that has been studied since at least the time of Torricelli. To fixate this in a student's mind, one could ask them to visualize a bathtub that is being drained through the plughole or a bottle being drained through a tap. This problem…

Sound is an interesting topic for physics lessons at all ages. However, it is difficult to illustrate this ubiquitous phenomenon and many models do not adequately represent the properties of sound and thus promote unwanted conceptions. The experiment presented here avoids this by visualising sound itself with the help of the schlieren technique.…

Archimedes' principle is one of the foundation subjects in physics. Normally the principle is exemplified by reference to floating boats. However, Archimedes' principle also applies to objects embedded in waterlogged ground, which can lead to the surprising result of an object weighing several tons being lifted. A practical example is presented of…

We propose a semiquantitative experiment that associates video-analysis and ordinary procedures of experimental physics whose objective is to investigate the dual character of Oobleck, a mixture of cornstarch in water, which appears thicker or thinner depending on how it is physically manipulated. The results are presented and interpreted taking…

In this article we consider a well-known simple, very accessible demonstration of surface tension with a small boat propelled by substances that change the surface tension of water. A simple quantitative evaluation is provided that matches well with experimental data. A modification to the experiment is proposed allowing it to continue for a long…

A glass of water covered with a disk with a hole in it can be turned upside down without spilling the water in the glass, provided the hole is small enough and the disk is pressed against the rim of the glass. A quasistatic numerical simulation based on hydrostatic pressure and surface tension of water was used calculate the critical hole diameter…