A general dichotomous condition is derived for the unidimensional polytomous Rasch model. The robustness of the dichotomous analysis is investigated in a simulation study. The model shows a close relation with the two-parameter Birnbaum model. (TJH)

It is demonstrated, theoretically and empirically, that item sets can be selected that meet the unidimensionality assumption of most item response theory models, even though they require more than one ability for a correct response. A method for identifying such item sets for test development purposes is presented. (SLD)

Concern has been expressed over the item response theory (IRT) assumption that a person's ability can be estimated in a unidimensional latent space. To examine whether or not the response to an item requires only a single latent ability, unidimensional ability estimates were compared for data generated from the multidimensional item response…

This paper develops and applies three nonparametric comparisons of the shapes of two item characteristic surfaces: (1) proportional latent odds; (2) uniform relative difficulty; and (3) item sensitivity. A method is presented for comparing the relative shapes of two item characteristic curves in two examinee populations who were administered an…

The purpose of this study is to determine an efficient way to reduce the bias in estimates of the Rasch model parameters due to aberrant response patterns. First, the benefits of using one- or two-sided goodness-of-fit tests of patterns with the model are discussed. Then, the consequences of removing non-fitting patterns from Rasch model data are…

The effects of variations in degree of range restriction and different subgroup sample sizes on the validity of several item bias detection procedures based on Item Response Theory (IRT) were investigated in a simulation study. The degree of range restriction for each of two subpopulations was varied by cutting the specified subpopulation ability…

The EM algorithm is used to derive maximum likelihood estimates for item parameters of the two-parameter logistic item response curves. The observed information matrix is then used to approximate the covariance matrix of these estimates. Simulated data are used to compare the estimated and actual item parameters. (Author/BW)

This report documents a computer program for simulation evaluation of item response theory (IRT) ability estimators. This Honeywell DPS version is a very slight modification of the program originally developed in FORTRAN-77 on a DEC VAX 11/780. The model of the world simulated by the program involves a unidimensional test in which the probability…

The results obtained from two basic types of pre-equatings of tests were compared: the item response theory (IRT) pre-equating and section pre-equating (SPE). The simulated data were generated from a modified three-parameter logistic model with a constant guessing parameter. Responses of two replication samples of 3000 examinees on two 72-item…

In this paper, the detection of response patterns aberrant from the Rasch model is considered. For this purpose, a new person fit index, recently developed by I. W. Molenaar (1987) and an iterative estimation procedure are used in a simulation study of Rasch model data mixed with aberrant data. Three kinds of aberrant response behavior are…

The Rasch Model and various extensions of this model can be formulated as a quasi loglinear model for the incomplete subgroup x score x item response 1 x ... x item response k contingency table. By comparing various loglinear models, specific deviations of the Rasch model can be tested. Parameter estimates can be computed using programs such as…

Two optimalization models for the construction of tests with a maximal value of coefficient alpha are given. Both models have a linear form and can be solved by using a branch-and-bound algorithm. The first model assumes an item bank calibrated under the Rasch model and can be used, for instance, when classical test theory has to serve as an…

The use of new extension of standard Item Response Theory (IRT) modeling of dichotomous items to include external variables is proposed. External variables may appear both as categorical grouping variables and as continuous variables; this requires the formulation of a model for the relationships between the external variables and the response…

In order to evaluate our methods and approaches of estimating the operating characteristics of discrete item responses, it is necessary to try other comparable methods on similar sets of data. LOGIST 5 was taken up for this reason, and was tried upon the hypothetical test items, which follow the normal ogive model and were used frequently in…

The effects of varying degrees of correlation between abilities and of various correlation configurations between item parameters on ability and item parameter estimation using the three parameter logistic model were examined. Ten two-trait configurations and one unidimensional test configuration for 30 item tests were simulated. Each…