Computer Aided Design and Drafting (CADD) programs are used to teach drafting at an Indiana high school. The school system's maintenance department shared use of the software and equipment to produce original drawings of school buildings. (MLF)

This drafting criterion-referenced test item bank is keyed to the drafting competency profile developed by industry and education professionals in Missouri. The 12 references used for drafting the test items are listed. Test items are arranged under these categories: drafting room procedures; tools and equipment; basic drawing skills; geometric…

This Missouri Vocational Instruction Management System instructor's drafting guide has been keyed to the drafting competency profile developed by state industry and education professionals. The guide contains a cross-reference table of instructional materials. Ten units cover drafting fundamentals: (1) introduction to drafting; (2) general safety;…

This guide, which is one of the curriculum guides in the "Exploration Curriculum Development Initiative" (Exploration) series intended to assist junior high and middle school industrial educators in helping their students explore diverse industrial situations and technologies used in industry, deals with using the language of industry. The…

Describes the process of metric conversion in residential drafting courses. Areas of concern are metric paper sizes; metric scale; plot, foundation, floor and electric plans; wall sections; elevations; and heat loss/ heat gain calculations. (SK)

Discusses the work of Isaac Edwards Clarke, an influential nineteenth-century U.S. education official. Reports that Clarke encouraged instruction in drawing as an important industrial skill. Indicates that, although interest in industrial drawing as an important aspect of art education waned by 1900, Clarke's influence continued to be felt. (SG)

This curriculum guide contains materials for a 17-unit course in advanced technical drafting, a followup to the basic technical drafting course in the industrial arts curriculum for grades 10-12. It is intended for use by industrial arts teachers, supervisors, counselors, administrators, and teacher educators. A three-page course overview provides…

These eight units of instruction are the products of a project conducted at Burlington County College in Pemberton, New Jersey, to develop three-dimensional computer graphics units of instruction for use in courses designed to train students in the areas of architectural, civil, drafting and design, and electronics technology. Addressed in the…

This computer-aided drafting (CAD) curriculum was developed to provide drafting instructors in Illinois with a useful guide for relating an important new technological advance to the vocational classroom. The competency-based learning activity guides are written to be used with any CAD system being used at the secondary and postsecondary levels.…

This task list is intended for use in planning and/or evaluating a competency-based course in drafting. The tasks required to perform the duties of seven types of drafters (i.e., general, architectural, electronic, civil, structural, mechanical, and process pipe drafters) and technical illustrators are outlined. The following are among the duties…

This Missouri Vocational Instruction Management System instructor's drafting guide has been keyed to the drafting competency profile developed by state industry and education professionals. The guide contains a cross-reference table of instructional materials. Two units are included: (1) orthographic drawings and (2) dimensioning. Each unit…

This Missouri Vocational Instruction Management System instructor's drafting guide has been keyed to the drafting competency profile developed by state industry and education professionals. This unit contains information on pictorial drawings. The guide contains a cross-reference table of instructional materials. The unit contains the following:…

This Missouri Vocational Instruction Management System instructor's drafting guide has been keyed to the drafting competency profile developed by state industry and education professionals. The guide contains a cross-reference table of instructional materials. This unit covers geometric dimensioning and tolerancing. The unit contains the…

This guide presents a plan for the complete secondary school technology education curriculum approved by the Technology Education Service in Virginia. Intended users are vocational administrators, program designers, guidance counselors, teachers, and students. It presents a curriculum structure for technology education and a chart of technology…

This Missouri Vocational Instruction Management System instructor's drafting guide has been keyed to the drafting competency profile developed by state industry and education professionals. The guide contains a cross-reference table of instructional materials. Three units cover related views and descriptive geometry: (1) auxiliary views and…