Publication Date
| In 2026 | 0 |
| Since 2025 | 0 |
| Since 2022 (last 5 years) | 0 |
| Since 2017 (last 10 years) | 0 |
| Since 2007 (last 20 years) | 1 |
Descriptor
| Course Evaluation | 2 |
| Course Objectives | 2 |
| Engineering Education | 2 |
| Engineering Technology | 2 |
| Behavioral Objectives | 1 |
| Chemical Industry | 1 |
| Chemistry | 1 |
| College Science | 1 |
| Course Descriptions | 1 |
| Course Organization | 1 |
| Design | 1 |
| More ▼ | |
Publication Type
| Journal Articles | 2 |
| Guides - General | 1 |
| Reports - Research | 1 |
Education Level
| Higher Education | 1 |
| Postsecondary Education | 1 |
Audience
| Practitioners | 1 |
Location
| New York | 1 |
Laws, Policies, & Programs
Assessments and Surveys
What Works Clearinghouse Rating
Direct linkDahle, Reena; Rasel, Rafiul – IEEE Transactions on Education, 2016
This paper presents a series of course modules developed as a high-impact and cost-effective learning tool for modeling and simulating the microfabrication process and design of microelectromechanical systems (MEMS) devices using three-dimensional (3-D) printing. Microfabrication technology is an established fabrication technique for small and…
Descriptors: Educational Technology, Learning Modules, Electromechanical Technology, Printing
Peer reviewedFelder, Richard M.; Marsland, David B. – Chemical Engineering Education, 1979
Describes an undergraduate chemical engineering course which was designed at North Carolina State University to introduce the experimental side of chemical process technology. The course lectures, experiments, objectives, evaluation and information sources are also discussed. (HM)
Descriptors: Chemical Industry, Chemistry, College Science, Course Descriptions
