It is difficult for an instructor to just make up valid numbers for B[subscript x], B[subscript y], B[subscript z], E[subscript x], E[subscript y], and E[subscript z] in the creation of homework problems and test questions calculating the Poynting vector. In this paper, 25 examples are given of the electric and magnetic fields of electromagnetic…

The calculation of the magnetic field produced by a loop current using the Biot-Savart law is a very typical exercise in introductory university physics. However, the cases studied are limited, in most textbooks, only the circular arrangement is treated. In this article, we calculate the magnetic field of an elliptical loop current along an axis…

Science and engineering students in the second semester of a calculus-based physics sequence typically study and measure the on-axis magnetic field for a multiple, circular turn coil. There are four benefits to this approach: 1) an analytical solution is easily obtained, 2) the coil is easily constructed using tightly wound, high-gauge wire where…

Interaction forces between magnetic fields and current loops play a central role in the theory of magnetism. This work describes a reasonably simple and cheap experiment for demonstrating this issue: the force on a thin coil due to a nearby cylindrical magnet. The magnitude of the force as well as its attractive/repulsive character is comfortably…

There have been a few methods described in this journal and elsewhere for measuring the wavelength of the standing electromagnetic waves in a microwave oven. Typically, these involve melting chocolate, cheese, or some other substance on a plate that is prevented from rotating. In this article I describe a more dynamic and colorful technique that…

It can readily be demonstrated that when a low frequency alternating voltage is applied to an iron-core coil the impedance is much higher than the direct current resistance of the coil. To understand how the high level of impedance arises it is necessary to explain how magnetic and electrical induction give rise to a current in the coil that…

If we drop a magnet through a coil, an emf is induced in the coil according to Faraday's law of electromagnetic induction. Here, such an experiment is done using expEYES kit. The plot of emf versus time has a specific shape with two peaks. A theoretical analysis of this graph is discussed here for both short and long cylindrical magnets.…

There is no doubt that integrated concepts inspire students and take learning to a new level. As we fly, we fly through the magnetic field of the Earth. We used the concepts involved in flying to develop an exercise that bonds geology, physics and life sciences.

A computational experiment investigating the [superscript 1]H and [superscript 13]C nuclear magnetic resonance (NMR) chemical shifts of molecules with unpaired electrons has been developed and implemented. This experiment is appropriate for an upper-level undergraduate laboratory course in computational, physical, or inorganic chemistry. The…

A simple inductive gravimeter constructed from a rigid plastic pipe and insulated copper wire is described. When a magnet is dropped through the vertically mounted pipe it induces small alternating voltages. These small signals are fed to the microphone input of a typical computer and sampled at a typical rate of 44.1 kHz using a custom computer…

The magneto-kinematic effect has been previously observed for the case of a rotating permanent magnet. Using this effect, this paper presents a novel method for calculation of the induced electromotive force (EMF) in a conductor for the case of rectilinear motion of a 25.4 mm diameter permanently magnetized sphere (magnetic dipole) past the…

This article comes from a question asked by a student of mine: if the Sun radiates energy in the form of electromagnetic waves, could they shift the Earth from its current orbit on a suitable timescale? The answer to such a question is apparently obvious and trivial. Nevertheless, it requires an instructive reasoning and interesting estimates of…

We examine a generalization of the one-dimensional Ising model involving interactions among neighbourhoods of "k" adjacent spins. The model is solved by exploiting a connection to an interesting computational problem that we call ""k"-SAT on a ring", and is shown to be equivalent to the nearest-neighbour Ising model in the absence of an external…

Proton beams have been colliding at 7 TeV in the Large Hadron Collider (LHC) since 30 March 2010, meaning that the LHC research programme is underway. Particle physicists around the world are looking forward to using the data from these collisions, as the LHC is running at an energy three and a half times higher than previously achieved at any…

This paper presents a simple method for calculating Clebsch-Gordan coefficients for the tensor product of two unitary irreducible representations (UIRs) of the rotation group. The method also works for multiplicity-free irreducible representations appearing in the tensor product of any number of UIRs of the rotation group. The generalization to…