Publication Date
| In 2026 | 0 |
| Since 2025 | 0 |
| Since 2022 (last 5 years) | 0 |
| Since 2017 (last 10 years) | 0 |
| Since 2007 (last 20 years) | 2 |
Descriptor
| Engineering Technology | 2 |
| Learning Modules | 2 |
| Printing | 2 |
| Behavioral Objectives | 1 |
| Concept Teaching | 1 |
| Cost Effectiveness | 1 |
| Course Evaluation | 1 |
| Course Objectives | 1 |
| Course Organization | 1 |
| Design | 1 |
| Educational Technology | 1 |
| More ▼ | |
Author
| Campbell, S. A. | 1 |
| Dahle, Reena | 1 |
| Jalali, M. | 1 |
| Kirchhoff, A. L. | 1 |
| Lawrenz, F. | 1 |
| Marti, J. J. | 1 |
| Rasel, Rafiul | 1 |
Publication Type
| Journal Articles | 2 |
| Reports - Descriptive | 1 |
| Reports - Research | 1 |
Education Level
| Higher Education | 2 |
| Postsecondary Education | 1 |
| Secondary Education | 1 |
Audience
Location
| New York | 1 |
Laws, Policies, & Programs
Assessments and Surveys
What Works Clearinghouse Rating
Peer reviewed
Direct linkDahle, Reena; Rasel, Rafiul – IEEE Transactions on Education, 2016
This paper presents a series of course modules developed as a high-impact and cost-effective learning tool for modeling and simulating the microfabrication process and design of microelectromechanical systems (MEMS) devices using three-dimensional (3-D) printing. Microfabrication technology is an established fabrication technique for small and…
Descriptors: Educational Technology, Learning Modules, Electromechanical Technology, Printing
Jalali, M.; Marti, J. J.; Kirchhoff, A. L.; Lawrenz, F.; Campbell, S. A. – IEEE Transactions on Education, 2012
A lithography lab course has been developed that is applicable to students from the middle-school level up to college students. It can also be inserted into electronics technology or similar courses in two- and four-year colleges, or used to demonstrate applications of polymers in chemistry classes. Some of these techniques would enable research…
Descriptors: Technology Education, Research Tools, Concept Teaching, Scientific Concepts
